Strip five gauges, cut copper, twist wires, split sheathing, and verify a line is dead—without climbing down the ladder. VoltEdge is a single eight‑function tool that replaces a stripper, cutter, and voltage tester on the job.
Five gauge notches cover 1.0, 1.5, 2.0, 2.5, and 4.0 mm², delivering clean jacket removal with no copper nicking. It handles both stranded and solid copper within 1.0–4.0 mm², and the stripping notches plus the splitting jaw are forged from SK5 high‑carbon steel to stay sharp through extended use.
The built‑in live‑wire tester sits in the handle: press the contact pad to see green when the circuit is dead, or red with a buzzer when live, so no extra tool or guesswork is necessary in crowded boxes.
VoltEdge employs a split‑hole and winding‑hole head design: one slot grips the cable while the other twists conductors into a neat pigtail. The slender needle‑nose tip pulls wires from tight box backs, the SK5 cutting jaw handles 1.0–4.0 mm² stranded or solid copper, and the stripping notches sit just behind the cutter so you don’t need to shift your grip. The voltage sensor is located in the handle, away from the jaw to keep your hand clear; green indicates safe, red plus buzzer means stop and switch off the breaker before proceeding.
Three tools on your belt, all in one: strip, slice, and test the same wire without putting one tool down. Five gauges map to 1.0, 1.5, 2.0, 2.5, and 4.0 mm² (roughly 17–11 AWG); the blade cuts copper cleanly; and the built‑in LED plus buzzer provides a live check without a separate tester.
| Why VoltEdge Replaces Three Tools on Your Belt | Generic 5-in-1 Multi-Strippers | Klein Stripper + Separate NCVT Pen |
|---|---|---|
| 8 Functions in One Tool: strip, cut, wind, split, press, clamp, cable-strip, voltage-test | ❌ | ❌ (need two tools) |
| SK5 Gauge-Matched Stripping Notches: 1.0, 1.5, 2.0, 2.5, and 4.0 mm² for clean conductor every time | ❌ (one-size notch) | ✅ |
| Non-Contact LED + Buzzer Voltage Check Built Into Handle: no second pen, no fumbling for the tester | ❌ | ❌ (separate device) |
Step 1: insert the wire into the matching notch, then squeeze so the SK5 blade cleanly strips the jacket without contacting the conductor. Step 2: use the long‑nose tip to twist conductors or move to the winding or split hole for tidy pigtails and sheath splitting. Step 3: press the insulation with the contact pad to verify dead or live; green means safe, red with buzzer means stop and switch off the breaker before proceeding.